Garin Gardiner

Autodesk Manufacturing Blogs

March 2011

Sun Mon Tue Wed Thu Fri Sat
    1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31    

« What is Inventor Fusion? | Main | Take a Picture! »

02/10/2009

Comments

Feed You can follow this conversation by subscribing to the comment feed for this post.

MICHAEL MULDER

Garin, I'm trying to do a stress analysis on a cantilevered beam with a constraint at an end and one in the middle. it seems as if I should use the beam and column calc but can this be done with the stress analysis? why use the stress analysis at all? thanks!

Garin Gardiner

For many things that you design with Frame Generator, you can calculate each member with the calculators. For things that aren't plates or standard extrusions I would run them through stress analysis.

The comments to this entry are closed.

RSS Feed

  •   Subscribe